top of page
  • The Glitterati

NEWS FROM THE SSEF

TWO EXCEPTIONAL ASTERIATED DIAMONDS


Figure 1: Two exceptional asteriated diamonds received at SSEF. From left to right: octahedron showing six brownishlobes (3.72 ct); flat half-octahedron showing three lobes(3.77 ct); sideviewof the second stone showing the three-dimensional natureof the lobes. Photos: A. Chalain.

Recently, SSEF received two so-called asteriated diamonds for authentication. Asteriated diamonds are rare and highly prizedamongst collectors for their beautiful and unique appearance. The two stones receivedin our lab were no exception. The two polishedrough crystals (3.72 and 3.77 ct) contained brownish to whitish clouds of microscopically small inclusions that formed a star-shape in three dimensions that is visible with the naked eye.

One of the two stones is an almost perfect octahedron with resorbed corners and edges that have been partly polished (see Figure 1). It showssix lobes of inclusion clouds that radiated from the centre of the crystalto its corners. The other stone had a flattened shape with one three- and one six-sided face on opposite sides. The star-shaped clouds in this stone formedthree petals that extended from a pointclose to the centre of the six-sided face towards the corners of the triangular (octahedral) face.

At first glance, the second stone looked similar to a macle (a twin occurring along a plane parallel to the octahedral face), however maclesusually have two trigonal (octahedral) faces on oppositesides and showre-entrant angles. Both features were absent on this stone.A more likely explanation for its shape is that the stone represents only half of an octahedron that is truncated at the centre of growth in a plane parallel to one of the octahedral crystalfaces. This would result in the described shape while also explaining why three instead of six lobes of of inclusions were visible in this stone.There were no visible remnants of the missing three lobes near the hexagonal face, indicating that the stone was not cut or cleaved to achieve this shape. Instead, the shape may have occurred naturally in the Earth’s mantle, due to a restriction in growth on one side.


Figure 2: Left: map of the intensity of the hydrogen-related 3107cm-1 peak obtained on the triangular side of the half-octahedron. Dark blue: low intensity, yellow-green: high intensity. Right: microphotograph of the same stone showing approximately the same section of the stone at the same orientation. Width: 3.3 mm. Images: SSEF.

Figure 3: yellow-green fluorescence seen under LWUV light (365 nm). Left: octahedral stone showing six lobes, right: flat stone showing three lobes. In both cases, the fluorescence is most intense in the H-richzones. Photos: A. Chalain, SSEF.


Infrared (IR) spectroscopy revealed that both stones contain traces of aggregated nitrogen and are relatively rich in hydrogen. IR-mapping was performed on the flat three-lobed stone. A seriesof measurements was performed followingan imaginary grid on the triangular face of the diamond. The intensity of the peak at 3107 cm-1caused by the VN3H defect,was measured in each spot and the result used to createa ‘map’ that shows the distribution of this defectwithin the stone in 2-d (see Figure 2). The H-rich zones seen in the map agree exactly with the position of the visible lobes, confirming previous measurements on asteriated diamonds (Rondeauet al. 2004).

When viewed under conventional long-wave ultraviolet (UV) light(365 nm), the two stonesshow a relatively strong yellowish to green fluorescence that is strongest in the H-rich lobes (see Figure 3). DiamondView imaging did not reveal the same features. Instead, both stones show an irregularpattern of weak blue fluorescence. Additionally, the stone with six lobes showedweak greenish fluorescence towards the octahedral corners when viewedusing the DiamondView instrument. No phosphorescence was observed.

The star-shaped internal features seen in asteriated diamonds are a form of sector zoningthat develops when cuboid and octahedral sectorsgrow simultaneously. Hydrogen is incorporated preferentially into the cuboid sectors, whereas nitrogen concentration is higher in the octahedral sectors. The petal shape of the growth structure can be explained by variations in relative growth of the two types of sectors. The appearance of the cuboid sectors is caused by light scattered on ‘disk-crack-like’ inclusions that can be opaque or transparent and have been shown to contain graphite (Howell et al. 2013 and references therein).


* Dr. L. Speich & J.-P. Chalain


A three-dimensional model of the two stones can be viewed by scanning the following QR-code with your smartphone: therein).


REFERENCES Howell D., Griffin W., Piazolo S.,Say J.M., Stern R.A., Stachel T., Nasdala L., Rabeau J.R., Pearson N.J., O’Reilly S.Y.: Aspectroscopic and carbon- isotope study of mixed-habit diamonds: Impurity characteristics and growth environment, American Mineralogist 98 (2013), 66-77. Rondeau B., Fritsch E., Guiraud M., Chalain J.-P., Notari F.: Three historical ‘asteriated’ diamonds: growth history and sector-dependent impurity incorporation, Diamond & Related Materials 13 (2004), 1658- 1673.





* * This article originally appeared in the 2021 Facette and was reprinted with permission.

Download the 2021 Facette and stay up to date with SSEF's latest research & courses on their website

Follow SSEF on Instagram @ssefgemlab

bottom of page